|
|
 |
GR-910504
|
4PCS INJECTOR NOZZLE PULLER SET
|
---------------------------------------------------------------------
---------------------------------------------------------------------
|
|
CONTENTS:
SCREW OFF THE NOZZLE HEAD,SCREW IN THE PULLER SPINDLE,
INSERT THE SUPPORT RING,PUSH THE SUPPORT SLEEVE OVER
THE SPINDLE AND SCREW ON THE COLLAR NUT THEN PULL OUT
THE NOZZLE BY TURNING THE COLLAR NUT.
SUPPORT SLEEVE,PULL SPINDLE,SHOULDER NUT M16*1.5 ,
SUPPORT RING,SPECIAL BIT INSERT 10mm HEX,AXIAL BEARING ,
CIRCLIP,SPECIAL SOCKET INSERT 29mm HEX
FOR MERCEDES CDI MOTORE OM 611,612,613
PACKING:
BLOW CASE
20SET/22KGS/23KGS/1.3'
|
........... more
|
|
|
MZ-624930
|
VW‚AUDL DSG TRANSMISSION SPACER
|
---------------------------------------------------------------------
---------------------------------------------------------------------
|
|
*SPECIAL DESIGNED TO REMOVE LOAD FROM
PLUNGERS OF MECHATRINIC UNIT WHEN YOU
INSERT THE TOOL BETWEEN CLUTCH LEVER
AND GEAR HOUSING.
*APPLICABLE:VW‚AUDI 7-SPEED
DUAL CLUTCH GEARBOX.
*PACKING:
72PCS/13.4KGS / 14.4KGS / 2.5'
|
........... more
|
|
|
|
CU-8176
|
CLOW PLUG DRILLING SET
|
---------------------------------------------------------------------
---------------------------------------------------------------------
|
|
.Choose the NO.4 socket,install it onto the glow plug,use a hammer to fix the socket with glow plug head then try to remove the glow plug with 3/8”DR.Spanner.
.This tool is especially for the situation when removing the glow plug,but there is only head is removed then please use the other accessories to remove the rest glow plug hole and replace a new one.
.Insert NO.6 tube into the glow plug hole,then insert a No.10 O 3.5 drill into NO. 6 tube then drill a hole with air tool.
.Separate the NO. 9 device and only choose the cone center tool and install it into the glow hole.Choose suitable drill from NO.2 ( 7χ5.5 or 9χ5.5 or 8χ5.5 ) ,inert the drill into NO.8 drill installer .It is important to sue NO. 5 ( 3mm alley key )to lock the screw on drill installer . Then install it into cone center tool, and connect with air tool to drill and also remove the hex nut from glow plug.
|
........... more
|
|
|
FMC-14101
|
1/4
|
---------------------------------------------------------------------
---------------------------------------------------------------------
|
|
2 - 24 NEWTON METER / 0.2 - 2.4 M.KGS
|
........... more
|
|
|
|
